Planar Systems URW105 105" 5K 21:9 Ultra-Wide Commercial Monitor - Manual (Page 33)

33
Planar UltraRes W Series User Manual
020-1420-00A
Page | 33
16.7 Selecting Layouts and Input Sources
The Planar UltraRes W Series models can show 1 source or 2 sources at a time simultaneously
(see multi source view on page 35). These sources are referred to as "Zone 1" and "Zone 2" in
the Menu. Zone 1 and Zone 2 can be viewed simultaneously in either Picture-in-Picture (PiP) or
Picture-by-Picture (PbP). The multi-source modes can be accessed through the Inputs and
Views submenu (see page 35) or through direct commands from the IR remote or an RS232
control system. Different layouts can be saved and recalled with a single IR or RS232 command
(see IR Command Protocol on page 27).
Keypad
Press the Source button. The Zone 1 input source will be toggled sequentially.
Remote
The following methods can be used to change the inputs being displayed using the IR Remote.

Press the desired input on the remote to change the source displayed in Zone 1

Press the Source button to display the Zone 1 Source Menu, and choose the input to
display in Zone 1

Press the PIP button to toggle between the Single, Dual, and PiP Multi Source view
modes

When 2 zones are being displayed, Press the P-Source button to display the Zone 2
source menu, and use the directional keypad choose the desired input to display in Zone
2
Optional Remote (see page 30)

When 1 zone is displayed, press the desired input button on the remote to change the
source displayed in Zone 1

When 2 sources are displayed, Press the Zone 1 or Zone 2 buttons on the remote,
followed by the desired source button for the selected zone

Press the PIP Mode button to toggle between the Single, PiP and PbP modes

Press the SRC/Source button. The input source will be toggled sequentially.