Planar Systems URW105 105" 5K 21:9 Ultra-Wide Commercial Monitor - Manual (Page 44)

44
Planar UltraRes W Series User Manual
020-1420-00A
Page | 44
Power Saving Delay
• Sets the amount of time before initiating the standby state specified in Power Saving
Mode when no signal is present
• Options: 1 Minute, 5 Minutes, 15 Minutes, 30 Minutes, 60 Minutes; Default: 5 Minutes
Power Down Mode
• Set the action to take when the display enters standby
•
Options: Standby Mode, Networked Standby Mode, Fast Startup; Default: Standby Mode
•
Standby Mode: The lowest power standby setting. CEC, LAN, DB9 RS232, and USB
communication are disabled. IR, Keypad connector will remain active.
•
Note: To remove display from standby with the IR remote or keypad, IR Remote Lock
or Keypad Lock must be disabled.
• Networked Standby Mode: The display will enter a low power standby state with LAN,
DB9 RS232, USB and IR communications active.
•
Fast Startup: The display will enter a standby state with partially reduced power, allowing
for 3-5 second wait between an ON command being sent, and image being displayed. IR,
Keypad, CEC, LAN, DB9 RS232, and USB communication will remain active.