Autel Robotics EVO II Dual 640T Enterprise Bundle V3 Drone with Thermal Imaging - Manual (Page 21)

21
3. Insert a screw into a hole of the decorating part of the gimbal, and then screw it
in with a T6 screwdriver until the screw is fixed but not tightened. For the other
screw, repeat the same step. Fully tighten the two screws with a screwdriver.
4. Power on the aircraft. If the connector cable is successfully connected, the
gimbal will automatically rotate to perform a self-check.
4. Camera
Two kind of cameras are provided: 4k visual cameras and an infrared thermal
imaging camera. The thermal imaging camera can work in visual light, infrared light,
or in Picture-in-Picture mode. The 4k cameras can record videos at 3840x2160
video resolution and capture 50 million pixels photos. The infrared camera has a
resolution of up to 640x512.
The camera supports multiple photography modes, including Single, Burst, AEB,
Periodic, and HDR. Images are saved in DNG or JPG format, while videos are
recorded in MOV or MP4 format. Images and videos can be stored on the SD card
or the storage device of the aircraft.
5. Use the Micro SD Card
Before you turn on the aircraft, insert a micro SD card into a port, as shown below.