Autel Robotics EVO II Dual 640T Enterprise Bundle V3 Drone with Thermal Imaging - Manual (Page 47)

47
Chapter 4 Flight Operations
4.1 Pre-flight Checklist
Observe the following steps to perform a comprehensive pre-flight check:
 The aircraft, remote controller, and your mobile device are all fully charged.
 The gimbal protective cover has been removed.
 The propellers are mounted correctly and working properly.
 The antennas have been adjusted according to the instructions described in
Section 2.2.2.
 The aircraft has already paired with the remote controller.
 The firmware has been upgraded to the latest version.
 Make sure that you are familiar with flight control operations.
 Check whether the flight region is open with no blocking obstacles.
 Check the weather conditions including the temperature and wind speed.
 Check whether the camera lens of the aircraft and sensors are clean.
4.2 Flight Operations
The aircraft provides three command stick modes: mode 1, mode 2, and mode 3. In
each mode, you can control the aircraft differently. By default, mode 2 is used. You
can switch the modes using the Autel Explorer App. We recommend that beginners
use mode 2.
1. Basic procedure
1. Place the aircraft in an open area. Stand at least 3 meters away from the tail of
the aircraft.
2. Turn on your remote controller.
3. Turn on the aircraft and wait for the LED indicator at the tail to flash green slowly.
4. Start the motor using the remote controller and make the aircraft take off.
5. Carefully control the aircraft within your range of visibility.
6. Land the aircraft and turn off the motor.
4.2.1 Start the Motor and Take Off the Aircraft (Mode 2)
 As shown in the following figure, press the left and right sticks for 2 seconds to
start the motor.