Autel Robotics EVO II Dual 640T Enterprise Bundle V3 Drone with Thermal Imaging - Manual (Page 53)

53
Question 6: The video link fault occurs or is interrupted often.
 Check whether there is any magnetic or signal interference source near the
aircraft and remote controller.
Question 7: The camera automatically turns off during recording.
 Do not pull out the micro SD card from the camera. Restart the camera and wait
for the video file to be stored as much as possible.
Question 8: The video link is interrupted when the aircraft is not out of your sight.
 Enable auto-return and let the aircraft return to the home point.
Question 9: What precautions should I follow when using the omnidirectional
binocular vision sensing system?
 Ensure that 12 cameras are clean without being blocked before the flight.
"Omnidirectional" means that the system can sense objects in six directions,
including front, rear, left, right, up, and down.
 A blind zone of 30° degrees exists in the four diagonal directions of the aircraft.
Pay attention to the surrounding environment and safety prompt messages of
the app.
 Obstacles can be detected by checking the texture of their surfaces. The
detection function cannot work properly for objects with no texture, repeated
texture, or a surface of pure color, moving objects, or tiny objects.
Question 10: The accurate landing cannot work properly.
 This feature can be implemented by the binocular camera on the rear of the
aircraft. The camera detects the ground texture when the aircraft takes off.
 However, if the ground does not have any texture or the camera on the rear of
the aircraft is damaged, this feature cannot work properly.
Question 11: The omnidirectional binocular vision sensing system cannot work
properly.
 Restart the aircraft and check whether the system can work properly this time.