Autel Robotics EVO II Dual 640T Enterprise Bundle V3 Drone with Thermal Imaging - Manual (Page 24)

24
2.1.6 Intelligent Flight Features
1. Auto-return
This feature is enabled only when the GPS signal is good. To manually activate the
auto-return feature, long press the auto-return button
( ) on the remote
controller for 3s. After receiving the command, the aircraft will automatically return
and land at the preset home point.
EVO Ⅱ Dual 640T V3 can use its forward vision system to avoid obstacles in the
flight route. When the aircraft
is returning to the home point, the remote controller is not available, and you must
press the Pause button
( ) to activate the front vision system.
Warning
 If the forward vision system is not enabled when the aircraft is returning to the
home point, the aircraft cannot automatically avoid obstacles. Press the Pause
button on the remote controller
( ) to exit the auto-return mode and regain
control over the aircraft.
Important
 The default altitude for returning to the home point is 30 meters. If the
auto-return feature is activated when you fly your aircraft at a lower altitude, the
aircraft will ascend to the default altitude of 30 meters and then return to the
home point.
 If you activate the auto-return feature when the aircraft is within a 10 meters
radius of the home point, the aircraft will automatically land at the current place.
2. Failsafe
Failsafe is to help the aircraft return to the home point automatically or land at the
current place when necessary. Failsafe is activated in the following two scenarios:
 Communication interrupted
If the communication between the aircraft and the remote controller is interrupted
for 3s, failsafe will be activated.
If a GPS signal is available when the failsafe is activated, the aircraft will
automatically return to the home point. Otherwise, the aircraft will land in the current
place. After the communication is restored, you can press the Pause button (
)
to regain control over the aircraft.