Autel Robotics EVO II Dual 640T Enterprise Bundle V3 Drone with Thermal Imaging - Manual (Page 34)

34
Note
 Do not use other communication devices of the same frequency band at the
same time to prevent interference with the signals of the remote controller.
 In practice, when the image transmission signals are weak, the Autel Explorer
App will display prompt messages. Adjust the antennas according to the
prompted instructions and ensure that the aircraft is in the place for the best
communications.
5. Linking
When you buy a package that includes both an aircraft and a remote controller, the
remote controller is already linked to your aircraft before delivery. You can directly
use the aircraft after you activate it.
In other cases, you need to link the remote controller to your aircraft manually.
Perform the following steps to do that.
1. Press the linking button next to the USB port on the right of the aircraft body to let
the aircraft enter the linking state.
2. Turn on the remote controller and launch the Autel Explorer App. Go to the
mission flight page, and click the wheel icon on the upper right corner to go to the
settings menu. Click "Remote Controller -> Data Transmission and Image
Transmission Linking -> Start Linking" and wait for several seconds until the linking
is successful.
6. Calibrate the remote controller
If the stick works improperly, we recommend that you calibrate the remote
controller. You can use the Autel Explore App to calibrate the remote controller or
perform the following steps:
1. Turn on the remote controller. Go to the app camera page. Then click Setting
(
) -> Remote Controller -> Remote Controller Calibration. Two 米-shaped and
two horizontal bars will appear on the screen, representing the left and right
command sticks and dials, respectively.
2. Stick calibration: Push and hold the stick one by one in eight directions until you
hear a beep each time.
3. Dial calibration: Turn the dial clockwise until you hear a beep and then turn it
counterclockwise until you hear another one.
7. Command stick mode
Three command stick modes are provided: mode 1, mode 2, and mode 3. You can
set this in the Autel Explorer App based on your preferences. By default, "Mode 2" is