Edirol R-4Pro - Manual (Page 36)

36
Recording
You can record sound both from the mics connected to R-4 Pro XLR input connectors 3 and 4 and the
internal mics.
fig.input-analog.eps
● System settings
Press the R-4 Pro [SYSTEM] button.
In 1 Recording Setup, set Input Select to Int+Ana.
Set the Rec Mode to STEREOx2.
Set the other items in 1 Recording Setup as appropriate for the
recording you want to make.
* The internal mics cannot be used if the Rec Freq is set to 192 kHz.
If Rec Freq is set to 192 kHz after setting Int+Ana, the settings
automatically change to Dig+Ana.
* For more about system settings, refer to “System setup” (p. 64).
● Input level knobs
Adjust the input level.
Use the following to simultaneously record sound from internal mics and external mics.
* The input level knob [SENS] settings are invalid for the internal mics.
See Adjusting the input level (p. 31).
● Record button [REC]
Press the [REC] (record) button to begin recording.
For details on recording standby, refer to “Recording standby” (p. 32).
● Other settings
If you want to monitor the sound being recorded, connect headphones to the PHONES jack and use the
monitor level knob to adjust the volume.
Adjusting the monitor level knob does affect the level of the sound actually being recorded.
To play back the recorded sound, refer to “Playing back” (p. 37).
Simultaneously recording sound from connected
external mics and the internal mics
Channel 1 Internal mic L channel Input level knob 1
Channel 2 Internal mic R channel Input level knob 2
Channel 3 Analog input L channel Input level, SENS knob 3
Channel 4 Analog input R channel Input level, SENS knob 4
Microphone
R-4_e_new.book 36 ページ ２００６年１１月２０日 月曜日 午後１時９分