Edirol R-4Pro - Manual (Page 74)

74
System setup
Pre Record-
ing OFF , 1–29
sec
You can specify the length of time that the sound is captured “retroactively,”
starting from before the moment you pressed the [REC] (record) button. This
setting specifies the number of seconds that is captured retroactively.
* The maximum time depends on the sampling frequency, the sample size (bit
depth), and the mode setting.
* The R-4 Pro consumes power even during pre-recording. If you are running on
batteries, you should pay attention to the remaining battery charge.
* Please set Pre Recording to OFF when recording using timecode. If Pre Recording
is set, then the timecode will not match.
Project Name
Date,
Name1–8
This specifies how names are assigned to the recorded project files. You can se-
lect to base the name on the date and time or on the Project Name that you set.
If you choose Date, a project recorded at 3:45 and 12 seconds in the morning Jan-
uary 2, 2005, is given the name of “050102034512”.
If you use the Date setting, the name of the project indicates the time that it was
recorded; this is convenient when you have recorded a large number of projects
and are looking for a specific one.
If you choose Name, the project name is the name you set in “8 Project
Name” (p. 77) plus an ascending serial number. If you specify a clearly identi-
fiable project name, e.g., SCENE001, SCENE002, etc. the project files are grouped
together.
If you use the Name1–8 setting, the project name is the name you set in “8
Project Name” (p. 77) plus an ascending serial number. The serial number is
incremented automatically, e.g., R4_Scene1_001–R4_Scene1_999, up to 999.
The R-4 Pro uses the number of the highest serial numbered project name in the
current folder as the start value for the serial number.
Limiter link
1/2/3/4 The limiter is applied independently to each channel.
1+2/3+4
The limiter for channels 1 and 2 is linked. In addition, the limiter for channels 3
and 4 is linked.
1+2+3+4 The limiter for all channels is coupled.
1+2/3/4
The limiter for channels 1 and 2 is linked. The limiter for channels 3 and 4 is ap-
plied independently.
1/2/3+4
The limiter for channels 3 and 4 is linked. The limiter for channels 1 and 2 is ap-
plied independently.
Menu item Value Function
Rec Freq. Rec Bit Rec Mode Pre Recording
44.1
44.1
48
48
48
48
88.2
88.2
96
96
192
16
16
16
16
24
24
24
24
24
24
24 29
14
27
13
18
9
9
4
8
4
4
STEREO x1
STEREO x2
STEREO x1
STEREO x2
STEREO x1
STEREO x2
STEREO x1
STEREO x2
STEREO x1
STEREO x2
STEREO x1
R-4_e_new.book 74 ページ ２００６年１１月２０日 月曜日 午後１時９分