Edirol R-4Pro - Manual (Page 58)

58
Editing
This command changes the timecode for the data recorded in BWF format.
* The Edit Timecode screen does not display for non-BWF formatted data.
fig.merge-1.eps
1
Press the R-4 Pro [WAVE EDIT] button. The Wave Edit
Menu screen is shown.
2
Use the [CURSOR] buttons to select Edit Timecode , and
press the [ENTER] button.
A edit screen as shown in the figure is displayed.
fig.merge-2.eps
3
Use the [CURSOR] button to select the input location,
and then set the timecode with the [SCRUB/VALUE]
dial.
* H:M:S:F: indicates Hours: Minutes: Seconds: Frames, respectively.
The F value differs according to the Frame Rate value in the timecode
Setup.
* To cancel the settings, press the [EXIT] button.
fig.merge-3.eps
merge-3.eps
4
If you are satisfied with the settings, press the [ENTER]
button to confirm.
* Do not turn off the power while a project is being saved or while a
process is running.
* It may take some time to save the project if it contains a large amount
of data.
Edit Timecode
R-4_e_new.book 58 ページ ２００６年１１月２０日 月曜日 午後１時９分