Edirol R-4Pro - Manual (Page 47)

47
Finder functions
fig.finder-1.eps
1
While the Main screen is shown in the display, press the
[ENTER/FINDER] button. The Finder screen shown in
the figure is displayed.
Projects are shown in descending alphabetical order.
fig.finder-select.eps
2
In the Finder screen, use the [CURSOR] up/down
buttons or the [SCRUB] dial to select the copy source
project (the project you want to copy). Then press the
[ENTER] button.
If the desired project is in a folder, the hard disk (HD), or the external memory device (EX), you
can press the [CURSOR] right button to move into the selected folder (i.e., move to a lower-
level folder).
If you want to move back to the upper-level folder, press the [CURSOR] left button.
fig.finder-cf.eps
* If you want to select the external memory device, select the hard disk
(HD) and then press the [CURSOR] left button to show the
external memory device (EX). However, if the external memory device
is not mounted, it will not be displayed. See Connection and
removal (p. 79)
* Press the [CURSOR] right button after selecting EX to reference
the external memory device contents.
fig.finder-copy1.eps
3
When the screen shown in the figure is displayed, use the
[CURSOR] buttons to select
4 Copy .
fig.finder-copy2.eps
4
Use the [CURSOR] up/down buttons or the [SCRUB/
VALUE] dial to select the copy destination folder (the
folder to which you want to copy the project). Then press
the [ENTER] button to execute the Copy operation. You
can also select
HD (hard disk) or EX (external memory
device) as the copy destination,.
* If you decide to cancel without copying, press the [EXIT] button.
fig.finder-copy3.eps
Do not turn off the power while a project is being copied.
* If the copy destination contains an identically named project, a number
such as -1 or -2 is appended to the name of the copied project.
Copying a project (Copy)
R-4_e_new.book 47 ページ ２００６年１１月２０日 月曜日 午後１時９分