Playing back, Connections before playback, Connecting headphones – Edirol R-4Pro User Manual
Page 37: Connecting amplified speakers, Playing back” (p. 37)
37
Playing back
This section explains how to play back audio recorded on the R-4 Pro and projects on the R-4 Pro internal
hard disk. Make the correct settings and connections before playing anything back.
• Connections before playback.............................. (p. 37)
• Setup before playback........................................... (p. 39)
• Playing back ............................................................. (p. 41)
Headphones are a convenient way to monitor while recording or to check sound immediately after
recording.
1.
Turn the [MONITOR] level knob all the way to the left to minimize the volume.
2.
Connect your headphones to the PHONES jack.
3.
Slowly turn the [MONITOR] level knob toward the right to adjust the volume.
The following describes how to connect amplified speakers that have line input jacks or a digital input jack.
1.
Switch off the power to the R-4 Pro.
2.
Minimize the volume of the speakers you want to connect, and then turn off the power.
3.
Depending on the type of speakers you are using, connect the amplified speakers to the R-4 Pro
[LINE OUT] line output jacks or [DIGITAL OUT] digital output connector.
4.
Switch on the R-4 Pro power.
5.
Switch on your speakers, and gradually increase the volume to the desired level.
* You cannot adjust the volume of the audio output from the R-4 Pro line output jacks.
The following describes how to connect a mixer or other audio device that has line input jacks.
1.
Switch off the power to the R-4 Pro.
2.
Minimize the volume of the mixer or other device being connected.
3.
Connect the mixer to the R-4 Pro [LINE OUT] line output jacks.
You will need separately available audio cables (not included) to connect to the R-4 Pro line output jacks.
* Line output can be output as 4-indiv or monitor. See “System Setting" in “5 System Setup” (p. 75) for details.
4.
Switch on the R-4 Pro power.
5.
Switch on your mixer, and gradually increase the volume to the desired level.
* You cannot adjust the volume of the audio output from the R-4 Pro line output jacks.
Connections before playback
Connecting headphones
Connecting amplified speakers
Connecting a mixer or other analog device
(analog connection: line output jacks)
R-4_e_new.book 37 ページ ２００６年１１月２０日 月曜日 午後１時９分