Edirol R-4Pro - Manual (Page 75)

75
System setup
2 Player Setup
Parameter Value Function
Play Mode
Single
This selects the playback mode.
Only the selected project will play.
Sequential
All projects in the folder containing the currently selected project are played se-
quentially.
Repeat OFF , ON
This selects whether playback will repeat.
If Play Mode is set to Single, only that project is played repeatedly. If Play
Mode
is set to Sequential, the projects in the folder containing the currently se-
lected project play to the end of the list, and then the projects in that same folder
play sequentially again from the beginning of the list.
3 Speaker
Parameter Value Function
Speaker
Switch
OFF , ON
This switches the internal speakers on/off.
* Even if this is set to on, no sound is produced by the internal speakers during
recording standby or recording if the Recording Setup parameter Input Select
is set to IntMic; the speakers also remain silent while headphones are being used.
4 LCD Setup
Parameter Value Function
Contrast 1–5–10
This adjusts the LCD contrast. Higher settings emphasize the white areas of the
display.
BackLight OFF, 1–10
This adjusts the brightness of the LCD backlight.
The OFF setting turns the backlight off.
Higher settings make the backlight brighter and consume more power. If you
are operating the R-4 Pro on battery power, pay attention to the remaining
amount of battery capacity.
BackLight
Timer
OFF , 2 sec,
5 sec, 10 sec,
20 sec
Sets the amount of time until the display backlight turns off when no operations
have been performed on the R-4 Pro.
If you are operating the R-4 Pro on battery power, use this setting to conserve
battery life.
5 System Setup
Parameter Value Function
Battery
Time Alkaline ,
Ni-MH
Sets the type of batteries you are using.
Choose the Alkaline setting if you are using alkaline batteries, or Ni-MH if you
are using nickel metal-hydride batteries.
* If you choose a setting that does not match the type of batteries that are actually
installed, the remaining battery power indication will be incorrect.
Ext-Power
Adapter ,
9.0/9.5/
10.0/10.5/
11.0/11.5/
12.0V Sets the final voltage when using an external power source. The "Battery Low!"
message is displayed when the voltage of the external power source drops be-
low the set voltage.
Output Sel
4-indiv
Sets the sound output type.
The sound from each channel from LINE OUT is output without modification.
monitor Sound is output according to the output assignments
R-4_e_new.book 75 ページ ２００６年１１月２０日 月曜日 午後１時９分