Edirol R-4Pro - Manual (Page 57)

57
Editing
If the currently selected project consists of multiple files (MONO x2, MONO x3, MONO x4, STEREO x2),
this command merges them into a single channel.
How Rec Mode will change
* Since MONO x1, STEREO x1, or 4 ch. projects cannot be merged, the Merge command does not appear in the
menu when selecting these projects.
fig.merge-1.eps
1
Press the R-4 Pro [WAVE EDIT] button. The Wave Edit
Menu screen is shown.
2
Use the [CURSOR] buttons to select 4 Merge , and press
the [ENTER] button.
fig.merge-2.eps
The editing screen shown at right is displayed.
If you want to adjust the level (Mix Level) of the channels in the
project, you can do so. Use the [CURSOR] up/down buttons or
the [SCRUB] dial to specify the value.
For example, in a stereo two-channel project (STEREO x2), you
might set the Mix Level to -6.0 dB so that the level of each channel
will be lowered by 6 dB when they are merged.
* If you decide to cancel the settings, press the [EXIT] button.
fig.merge-3.eps
3
If you are satisfied with the settings, press the [ENTER]
button to confirm.
If you decide not to cancel Merge, press the [EXIT] button.
Even when the screen shown at the right is displayed, you can
cancel the process by pressing the [EXIT] button.
* Do not turn off the power while a project is being saved or while a process is running.
* It may take some time to save the project if it contains a large amount of data.
Merge
Before Merge After Merge
MONOx2
MONOx3
MONOx4 MONOx1
STEREOx2 STEREOx1
fig.media-full.eps
If the internal hard disk does not have enough space to save the project, a
“Media Full!”
message is shown.
R-4_e_new.book 57 ページ ２００６年１１月２０日 月曜日 午後１時９分