Ericsson RX8000 Series - Manual (Page 173)

Chapter 6
This option enables the conversion of HD video from 720p to 1080i or from 1080i to
720p.
6.2.34 Framesync (RX8200/SWO/FSYNC)
This option is only available for the RX8200 Receiver.
This option enables the framesync input, which allows the unit to synchronise the
video/audio playout of the unit to an external clock so that all synchronized
equipment will output A/V frames at the same time.
6.2.35 4 x Audio Capability (RX8200/SWO/4AUD)
This option is only available for the RX8200 Receiver.
This option enables up to 6 decodes (2 ‘basic’ and 4 ‘advanced’). The 4 extra
‘advanced’ audios are compatible with MPEG-1 Layer II, Dolby Digital, AAC, Dolby
E and linear audio. With this option you can embed up to 6 channels of audio into
the (HD)SDI video output. If four stereo pairs of physical audio interfaces are
required, two audio output cards will need to be installed.
6.2.36 Low Latency Decode (RX8200/SWO/LDELAY)
This option is only available for the RX8200 Receiver.
This option enables low latency video decode and will operate on MPEG-1 Layer II
audio only. With this license, low delay modes are available which cut down the
decode unit end-to-end delay within the unit. These lower delay modes will not work
under all transport conditions and should be used under consultation with Ericsson.
EN/LZT 790 0005 R1A 6-15