Ericsson RX8000 Series - Manual (Page 163)

Chapter 6
6.1.1 DVB-S2 Input Card (RX8200/HWO/DVBS2)
This option is only available for the RX8200 Receiver and is fitted as standard to the
base models of RX8310, 8315 and 8330.
With accompanying software options, the DVB-S2 Input card supports DVB-S,
QPSK demodulation and DVB-S2, QPSK and 8PSK demodulation.
RX8200/HWO/DVBS2 provides four L-band inputs.
Cautions!
The receiver provides DC power (refer to Chapter 3, Operating the Equipment
Locally) via the active L-Band input connector to drive an LNB (Low-Noise Block
Down-Converter). Do not connect equipment other than an LNB to this connector.
Failure to do this may result in damage to the external equipment.
The F-type Connector is not suitable for repeated connection and disconnection.
When intended for use in this way, fit a sacrificial connector and connect to it.
6.1.2 8-VSB Input Card (RX83XX/HWO/8VSB)
This option is only available for the RX8320 ATSC Broadcast Receiver.
The 8-VSB Input card supports ATSC demodulation.
6.1.3 Gigabyte 100/1000Base T Ethernet (RX8XXX/HWO/IP/GIGE)
This option is available for the RX8320 ATSC Broadcast Receiver and the RX8200,
8315, 8320 and 8330 DVB Receivers.
The 100/1000Base T Input card supports an MPEG transport stream over IP and
SMPT 2022 Pro-MPEG FEC with license key. Two 100/1000 Base T inputs are
provided and this system also has a very low latency level.
6.1.4 G.703 ATM Input Card (RX8XXX/HWO/G703)
This option is available for the RX8320 ATSC Broadcast Receiver and the RX8315,
8320 and 8330 DVB Receivers.
The G.703 ATM input card provides E3 or DS-3 inputs and offers a choice of 34 or
45 Mbps rates.
6.1.5 MPEG-2 4:2:2 SD Decoding Card (RX82XX/HWO/MP2/422)
This option is only available for the RX8200 DVB Receiver.
EN/LZT 790 0005 R1A 6-5