Ericsson RX8000 Series - Manual (Page 88)

Chapter 3
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
To enable/disable the Auto Tune function:
1. Press the Edit key. The cursor appears below the current option.
2. Use the S (Up) and T (Down) keys to toggle between the Enabled/Disabled
options until the required option is displayed.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
3.5.5 2 Input (G703 ATM Input Card RX8XXX/HWO/G703)
The Input menu is used to select the various inputs to the equipment and set input
parameters. To access the Input menu from the System menu, press the T (Down)
key. The following screen is displayed:
INPUT |UNLOCKED INPUT: G.703
2 |--- Mbits/s --- >
Note: The G.703 front panel menus may change depending upon the model of
G.703 card fitted, please refer to Ericsson for more information.
3.5.5.1 2.1 Select/Primary Input
To access this function, press the X (Forward) key. The following screen is
displayed:
INPUT |SELECT INPUT G.703
2.1 |PRIMARY INPUT G.703
The X (Forward) and W (Back) keys are used to choose the Select and Primary
input types.
To choose the Select input type:
1. Press the Edit key. The cursor appears below the displayed type (ASI shown
above).
2. Use the S (Up) and T (Down) keys to toggle between the available types:
G.703 and AUTO (dependent on model and option licences obtained).
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
To choose the Primary input:
1. Move to the Primary Input function using the X (Forward) key
EN/LZT 790 0005 R1A 3-40