Ericsson RX8000 Series - Manual (Page 152)

Chapter 5
Figure 5.33 Output Web Page
The following user-editable fields are displayed on this page.
User-editable fields in the Output section:
• TS (Transport Stream) Feed – allows selection of the type of transport stream
output from a drop-down menu.
• Output One/Two/Three – allows selection of the type of output from a drop-
down menu.
User-editable fields in the Filter Section:
• Service Filter Mode - allows selection of the Service Filter Mode from a drop-
down menu.
• Bitrate Type - allows selection of the Bitrate type from a drop-down menu.
• TS Output Constant Bitrate – allows the user to enter a value in Mbits/s.
Insert Nulls on Failure – checking this box will enure that CBR is maintained even
if the Transport stream is unlocked.
User-editable fields in the IP Out 1/IP Out 2 section:
• User TX Enable – checking this box enables the User Transmitter.
• IP – allows input of the IP address.
• Subnet – allows input of the Subnet mask address.
• Gateway - allows input of the gateway address.
• Src UDP (User Datagram Protocol) Port - allows input of the source UDP Port.
• IP Dest - allows input of the IP destination address.
• Dest UDP Port - allows input of the destination UDP port.
EN/LZT 790 0005 R1A 5-36