Ericsson RX8000 Series - Manual (Page 112)

Remote Control
4.3 Director
Ericsson’s Director Over-Air Control (OAC) system is available either as a standard
feature or as an option on all of the RX8000 Series Receivers, except for the
RX8320. OAC is a subset of the Director facility and is a remote control protocol
which is used to access the units using Ericsson’s nCompass Control System. An
Over-Air Download facility is also provided and a network connection is required for
this.
For more detailed information on Ericsson Director remote control, contact Ericsson.
4.3.1 Setting up Director Remote Control
For the unit to be controlled via OAC, the control mode of the RX8000 Receiver
needs to be set to Director OAC control mode. This can be achieved either via:
• the front panel, using menu 4.2 DIRECTOR and sub-menus, see Chapter 3,
Front Panel Control
• or the Web Browser Control interface, using the CA tab page, see Chapter 5,
Web Browser Control.
4.3.2 Over-Air Control (OAC) Lockout
When the unit is in OAC control mode, it is possible for the remote control operator
to issue a local lockout command to the Receiver. This will effectively deny the local
user access to configuring the unit.
However, if a situation occurs whereby the local user needs to regain control over
the unit, without a local lockout relinquish command being sent from the OAC
control PC, a four-digit Personal Identification Number (PIN) may be entered
through the keypad.
Caution!
Ericsson Customer Services Help Desk will not be able to provide you with the local
lockout PIN, as it is uniquely created at the time of the lockout.
The user creates the PIN at lockout time. To obtain the PIN, please consult the
person responsible for the administration of the unit.
EN/LZT 790 0005 R1A 4-4