Ericsson RX8000 Series - Manual (Page 137)

Chapter 5
• Mcast IP Address 1/2 – allows the user to set the Multicast IP Address for the
primary stream on Port 1/2.
• Source IP Address 1/2 – allows the user to set the Source IP Address for the
primary stream on Port 1/2.
• UDP Port 1/2 – allows the user to set the UDP Port Address for the primary
stream on Port 1/2.
• Column Port 1/2 – allows the user to set the Column Port Address for the
primary stream on Port 1/2.
• Row Port 1/2 – allows the user to set the Row Port Address for the primary
stream on Port 1/2.
• De-Jitter Buffer Level – allows the user to enter a value in milliseconds.
• Unicast Enable 1/2 – allows the user to enable Unicast for Port 1/2.
User-editable fields in the Redundancy Config Setting:
• Use Input Ports – allows the user to select the appropriate input port.
• Auto Revert Delay – allows the user to enter a value in seconds.
Two buttons, Clear ARP 1 and Clear ARP 2, are provided to allow the user to clear
the ARP cache for port 1 or 2. If these are selected the following window is
displayed:
Figure 5.21 Clear Arp Confirmation Window
If OK is selected, the Input>I/P Input page is displayed showing that the operation
has been successful.
EN/LZT 790 0005 R1A 5-21