HP 8360 - Manual (Page 332)

l
l
DIAGnostics:TEST:LOG[:STATe] ON|OFF|l|O
Selects and queries the raw data logging ON/OFF switch. Both
commands are executable in
mode.
After the setting is 0.
l DIAGnostics:TEST:LOOP ON|OFF|l|O
l DIAGnostics:TEST:LOOP?
Selects and queries the test looping ON/OFF switch. Both
commands are executable in
mode.
After the setting is 0.
l DIAGnostics:TEST:NAME?
Queries the name of a by number. If the number is not
specified then an array of all the names is returned.
l DIAGnostics:TEST:POINts?
Returns the number of points of that is output using
DIAGnostics:TEST:NAME? or DIAGnostics:TEST:RESult?.
l DIAGnostics:TEST:RESult?
Queries the result of a selftest, by number. The response is a string
containing either Passed, Failed, or
If <num> is missing,
an array of results are returned.
l DIAGnostics:TINT?
A test feature that returns the value passed to it. This is used to test
the HP-IB interface.
l ON|OFF|l|O
l
Sets and queries the display ON/OFF switch.
After the value is 1.
l FM:COUPling
l FM:COUPling?
Sets and queries the FM input coupling mode.
The *RST value is AC.
l
l
Sets and queries the peak FM deviation (in Hz) when the internal
FM generator is used. After the value is 1 MHz.
l FM:FILTer:HPASs
l FM:FILTer:HPASs?
Sets and queries the FM AC bandwidth. There are only two
Operating and Programming Reference HP 8360
User’s Handbook