HP 8360 - Manual (Page 338)

*RST state is AUTO.
l
l
Sets and queries the list of correction levels that correspond to each
of the frequencies entered using the LIST:FREQ command. The
attenuator is not allowed to change during the list execution. The
number of parameters can be from 1 to 801.
After the value is 0.
l [MAXimum|MINimum]
Returns the number of correction points that have been entered into
the list array. After returns a 1.
l LIST:TRIGger:SOURce
l LIST:TRIGger:SOURce?
Sets and queries the list point-to-point trigger source when in the
automatic list mode. See
and for more details.
*RST state is
l
l
Sets and queries the amplitude marker on/off switch. While [n] may
be used, there is really only a single switch for all the markers.
*RST value is OFF.
l
I
l MARKer[n]:AMPLitude:VALue? [MAXimum|MINimum]
Sets and queries the value of the amplitude marker. While [n] may
be used, there is really only a single value for all the markers.
value is 2
l
Sets all the markers to OFF at once. While [n] may be used, there is
really only a single switch for all the markers.
l
This query returns the difference in frequency between the two
specified marker numbers.
l MARKer[n]:FREQuency
l MARKer[n]:FREQuency? [MAXimum|MINimum]
Sets and queries the specified marker frequency (marker number
one is the default if [n] is not specified). The value is interpreted
differently based on the value of the marker mode.
Operating and Programming Reference HP 8360
User’s Handbook