Inputs & outputs, Inputs outputs rf – HP 8360 User Manual
Page 479
Inputs Outputs RF
output
Nominal output inpedance ohms
mm male on 20 and 26.5
models,
for negative external defector or power meter
Nominal input impedance
kohms, damage
volts.
RF Output
female,
Pulse
signal turns RF
When using
the
standard internal pulse
a
connector Nominal input
50 ohms, damage level
-05 volts See
Modulation
front
AM
Nominal input impedance 50 ohms
switchable to 2 kohms), damage level
volts See Modulation
front panel.)
Nominal input impedance 50 ohms (internally switchable to 600 ohms), damage level
volts. See
female, front panel.)
Activated on a
rising edge. Used to
initiate an analog
or to advance
to the next point in step or list mode. Damage level
-0.5 volts.
female, rear
output
Outputs a
pulse at 1601 points evenly spaced across an
analog
or at each point in step or list mode.
female, rear panel.)
10
Input
Accepts 10
100
0 to + 10
signal for operation from external time
Nominal input impedance 50 ohms. Damage level + 10, -5
female, rear
10
Reference Output
Nominal signal level 0
nominal output impedance 50 ohms.
female, rear
sweep output
Supplies a voltage
to the sweep ranging from 0 volts at start of
to
to percentage of full instrument
range. Minimum load impedance 3 kohms.
Sweep will stop when
extemally.
while
when
(approximately
Supplies voltage
to output
at 05
(internally
to
or
output volts Minimum load
2 kohms
mv, typical.
female, rear
-Module
bias, flatness correction, and
to
Modules (Special, front and rear
Change A
HP 8360
User’s Handbook