Holder C-Trac 4.74 - Manual (Page 100)

Operating instructions
149 443 99
C 4.74
Operating the implements
Turning on the rear PTO*
DANGER
Before turning on the PTO, make sure no-
one is standing close enough to the vehicle
and the driven implement to be hurt.
ATTENTION
Check the mounting angle of the cardan shaft.
Do not start it under 1500 rpm.
- Release the lock at the safety switch (1) and depress
the switch. The rear PTO is turned on.
- To turn it off, depress the safety switch at the top.
NOTE
If the engine temperature is too high, the PTO
will turn off automatically and an alarm will
sound. The engine must cool at idle speed
before being turned off. Restart the engine af-
ter checking for the cause. DANGER
After the installed implement is turned off, it
can continue to run. Wait until the implement
is stationary before working on it again.
1
Bild_C183
* Option