HP 3000dtn User Manual
Page 112
8-12
ENWW
z
Make sure the margin settings are correct
If the text or graphics are cut off at the edges of the page, make
sure the margin settings for the document do not exceed the
printable area of your printer. For more information about printer
margins, see the table of minimum margins in “
.”
Text or graphics are cut off at the edges of a page
z
Make sure the orientation settings are correct
The page orientation selected might not be correct for the
document you are printing. See “
” for instructions about changing print settings.
z
Make sure the margin settings are correct
If the text or graphics are cut off at the edges of the page, make
sure the margin settings for the document do not exceed the
printable area of your printer. The document margins must match or
exceed a margin setting of 4 mm (0.13 inch).
z
Make sure the content fits on the page
Content that is cut off might be outside the printable area. Or, the
size of the document you are printing is larger than the media size
in the main tray.
Check if the layout of the document you are trying to print will fit on
a media size supported by the printer, and then load the correct
media size. Make sure to select the correct page orientation.
z
Make sure the media is loaded correctly
Make sure the media width and length guides fit snugly but gently
against the edges of the stack. Also, make sure that the correct
page orientation is selected.
For more information about loading media, see “
.”
For more information about changing print settings, see “
.”
z
The software application cannot interpret print
settings properly
On the Starter CD, check the readme file for known software
conflicts. Otherwise, check your software application manual,
or contact the software manufacturer for more specific help for
this problem.