HP 3000dtn - Manual (Page 176)

B-6
ENWW
INCORRECT SUPPLIES Error At least one supply is incorrect and another
supply is missing, installed incorrectly, out, or
low. Press
(select button) for more
information about specific ink cartridges
and printheads.
Install any missing ink cartridges or
printheads. Press
(select button) to display
the status of the printer supplies on the
LCD control panel. If all supplies installed,
remove the ink cartridges and printheads.
(See “
Replacing printheads “ for more
information.) Verify that you are using the
correct ink cartridges and printheads, and
then firmly reinsert them into the printer.
You might need to repeat this several times.
If a printhead is still listed as one of the
incorrect supplies, clean the printhead
contacts. (See “
Cleaning the printhead
contacts “ for more information.) If the
printhead is still listed after cleaning, install a
new printhead.
Be prepared to replace the specific ink
cartridges and/or printheads with new ink
cartridges and/or printheads. For more
information about ordering ink cartridges and
printheads, see “
Ink cartridges ” and
“ Printheads ,” or visit http://www.hp.com .
For instructions on replacing ink cartridges
and printheads, see “
Replacing ink cartridges
and printheads .”
INITIALIZING Status The printer is initializing. Please wait.
INITIALIZING
PERMANENT STORAGE Status The printer is initializing. Please wait.
INSERT OR CLOSE
TRAY XX Error Tray XX is open or has been removed. Insert
or close Tray XX to allow printing to continue.
If the tray appears to be closed, it might not be
closed properly. Pull out the tray and close
it firmly.
Message Type Description