HP 3000dtn User Manual
Page 41
ENWW
3-9
To install memory and font DIMMs
CAUTION
DIMMs contain electronic components that can be damaged by
static electricity. To prevent buildup of static electricity, maintain
frequent contact with any bare sheet metal surface on the printer.
If possible, wear a grounding wrist strap (or similar device).
Handle DIMMs carefully at all times. Avoid touching electronic
components or circuit paths.
1
If you have not already done so, print a Configuration page to find
out how much memory is installed in the printer before adding more
memory. See “
.”
2
Press and hold
(power button) to turn off the printer.
3
Unplug the power cord and disconnect any cables.
4
To remove the DIMM cover from the back of the printer, insert a
flathead screwdriver into the top slot. Gently push down on the
screwdriver's handle with one hand, grasp the cover with the other
hand, and remove the cover.
5
Remove the DIMM from the antistatic package, and then align the
DIMM with an empty DIMM slot.
6
On the DIMM slot, push the DIMM locks outward to release
the locks.
7
Insert the DIMM into the slot (item 1 in the graphic) and press it into
the printer until it snaps into the slot (item 2 in the graphic).