Checking memory installation, Checking memory installation -10 – HP 3000dtn User Manual
Page 42
3-10
ENWW
Note
To remove a DIMM, the locks on the DIMM slot must be released
by pushing them outwards.
8
Replace the cover and gently apply pressure until the cover snaps
into place.
9
Reattach the power cord and any cables, and then turn on
the printer.
Checking memory installation
Follow this procedure to verify that DIMMs are installed correctly.
To check memory installation
1
Check that
READY
appears on the LCD control panel when the
printer is turned on. If an error message appears, a DIMM might
have been installed incorrectly.
For information about printer messages, see “
.”
2
Print a new Configuration page. Check the memory section on the
Configuration page and compare it to the Configuration page
printed before the DIMM installation. If the amount of memory has
not increased, one of the following problems might have occurred:
• The DIMM might not be installed correctly. Repeat the
installation procedure.
• The DIMM might be defective. Try a new DIMM.