HP 3000dtn - Manual (Page 45)

ENWW
4-3
Changing LCD control panel menu settings
The LCD control panel is one of three ways to set options in the printer.
You can also change options using settings in the printer driver and in
the applications from which you print. Printer driver and application
settings override LCD control panel settings for the current print job.
Application settings override default printer driver settings.
Menu items in the LCD control panel are numbered from 1-9. If a menu
has more than nine items, the additional items will appear with a letter
value from A to Z. However, the numbers and letter values are not
included in the procedures in this guide.
Items that have submenus appear with a plus sign (+) next to them.
If the second line of a two-line message is not visible, an ellipsis (...)
appears at the end of the first line of the message.
For more information about any LCD control panel menu or item,
press
(help button).
Note If you cannot gain access to a menu or item, it is either not an option
for the printer, or you have not enabled the associated higher-level
option. When items appear with a padlock symbol next to them,
a personal identification number (PIN) is required to change
the setting.
To change an LCD control panel setting
1 Press (select button) on the LCD control panel to enter the
menus.
2 Navigate to the menu or submenu that contains the setting you
want to change.
• Press (down arrow button) or (up arrow button) to highlight
the desired menu. (Hold down either of these buttons to
auto-scroll through the selections.) Press (select button) to
access the desired menu. Repeat this procedure to access
submenus.
• Press (down arrow button) or (up arrow button) to highlight
the desired setting, and then press (select button) to save the
setting. An asterisk (*) appears next to the setting in the display,
indicating that the new setting is now the default.
3 Press (pause/resume button) to exit the menus and return the
printer to the READY state. If no key is pressed for 30 seconds, the
printer returns automatically to the READY state.