HP 3000dtn - Manual (Page 60)

4-18
ENWW
EIO menu
The EIO (enhanced input/output) menu appears only when an EIO
device is installed (such as an HP Jetdirect print server). If the printer
contains an HP Jetdirect print server, you can configure basic
networking parameters using the EIO menu. Network printer
administrators can also use HP Web Jetadmin to configure these and
other parameters remotely.
Note The items available on the menu vary depending on the particular
print server that is installed.
Message Value or
Submenu Description
TCP/IP ENABLE
CONFIGURE
METHOD This item allows you to enable or
disable the TCP/IP menu and set the
TCP/IP protocol parameters.
In the TCP/IP menu, you can specify
BOOTP=YES or DHCP=YES for TCP/IP
parameters to be automatically
configured by a BootP or DHCP server
when the printer is turned on.
If you specify
BOOTP=NO and
DHCP=NO , you can manually set the
following TCP/IP parameters from the
LCD control panel:
z Each byte of the IP address (IP)
z Subnet Mask (SM)
z Syslog Server (LG)
z Default Gateway (GW)
z Idle Timeout period (default is 270
seconds; 0 disables the timeout)
When setting IP numbers, press (up
arrow button) to increase the number
by 1. Press
(down arrow button) to
decrease the number by 1. Press
(select button)
to make your selection.