HP 3000dtn - Manual (Page 61)

ENWW
4-19
Resetting the HP Jetdirect print server
Resetting the HP Jetdirect print server restores the factory default
values of the Jetdirect print server.
Note When you restore the factory default values for the HP Jetdirect
print server, all previously stored EIO settings are lost.
To reset the HP Jetdirect print server
1 Press and hold (power button) to turn off the printer.
2 While holding down both (select button) and (pause/resume
button) on the LCD control panel, turn on the printer.
IPX/SPX ENABLE
FRAME TYPE This item enables the IPX/SPX menu,
which you can use to set the IPX/SPX
protocol parameters.
In the IPX/SPX menu, you can specify
the frame type parameter used on
your network.
The default is
AUTO , which
automatically sets and limits the frame
type to the one detected.
For Ethernet cards, frame type
selections include
EN_8023 , EN_II ,
EN_8022 , and EN_SNAP .
For Token Ring cards, frame type
selections include
TR_8022 and
TR_SNAP .
In the IPX/SPX menu for Token Ring
cards, you can also specify NetWare
Source Routing parameters, which
include
SRC RT=AUTO (default), OFF ,
SINGLE R , or ALL RT .
APPLETALK ENABLE This item allows you to enable or
disable the AppleTalk protocol.
DLC/LLC ENABLE This item allows you to enable or
disable the DLC/LLC protocol.
LINK SPEED LINK SPEED This item allows you to manually set the
link speed (10 or 100 Mbs).
Message Value or
Submenu Description