HP 3000dtn - Manual (Page 65)

ENWW
5-3
To manually access TCP/IP parameters
1 Press (select button) on the LCD control panel to enter
the menus.
2 Press (down arrow button) to highlight CONFIGURE DEVICE ,
and then press (select button).
3 Press (down arrow button) to highlight I/O , and then press
(select button).
4 Press (down arrow button) to highlight EIO X (where X = 1 or 2),
and then press (select button).
5 Press (down arrow button) to select the parameter you want to
configure, and then press (select button).
6 Press (down arrow button) or (up arrow button) to highlight
the option you want to select, and then press (select button).
7 To configure other parameters, press (back button) repeatedly to
return to the CONFIGURE DEVICE menu, and then repeat steps 1
through 6.
-Or-
To return to the READY state, press (pause/resume button).
8 Repeat steps 3-7 to configure other parameters.
Setting the link speed
By factory default, the link speed is set to AUTO . Use the following
procedure to set a specific speed and communication mode.
To set the link speed
1 Press (select button) on the LCD control panel to enter
the menus.
2 Press (down arrow button) to highlight CONFIGURE DEVICE ,
and then press (select button).
3 Press (down arrow button) to highlight I/O , and then press
(select button).
4 Press (down arrow button) to highlight EIO X (where X = 1 or 2),
and then press (select button).
5 Press (down arrow button) to highlight LINK SPEED , and then
press (select button).