HP 3000dtn - Manual (Page 85)

ENWW
6-19
Printing on heavy media
When printing on heavy media (up to 0.52 mm or 0.02 inch thick), use
Tray 1. It provides a straight-through paper path that allows the printer
to handle heavy or thick media without bending or curling the media.
CAUTION Do not use media that is heavier than the media specification
recommended for this printer. Doing so can cause misfeeds, jams,
reduced print quality, and excessive mechanical wear.
See “
Selecting and loading print media .”
To print on heavy media using Tray 1
1 In the printer driver, select Manual Feed as the media source,
select the appropriate media type, and then print the document.
For more information about configuring settings in the printer driver,
see “
Using the printer driver .”
2 When the LCD control panel displays MANUALLY LOAD [TYPE]
[SIZE] , insert one sheet of media into Tray 1. Make sure the sheet
is facing up and is against the left edge of the tray.
For more information, see “ Loading Tray 1 .”
3 If you are printing more than one page, insert another sheet of
media when prompted by the LCD control panel.
To print on heavy media using the optional
multipurpose tray
Note The optional multipurpose tray is installed in the Tray 1 location.
1 Load the media face-up in the tray. Position the media against the
right edge of the tray, and then slide the media down into the tray.
For more information, see “ To load media in the optional
multipurpose tray .”
2 In the printer driver, select Tray 1 as the media source, and then
select the appropriate media type.
3 Print the document.