Holder C 9.92 H - Manual (Page 102)

C 9.92 Operating Instructions
100 153 146
Operating the attachments
Turning on the front PTO
DANGER
The PTO switch (1) must be switched off.
- Start the engine.
- Select the required PTO SPM with the PTO push-pull
rod (3).
NOTE
The push-pull rod (3) is located at the front
right at the front bracket.
DANGER
Before turning the PTO on, make sure that
no-one is standing close enough to the trac-
tor and the driven attachment to be hurt.
The PTO gear has 3 positions.
The possible positions are shown on the instruction plate (2).
- Set the push-pull rod to the centre position.
The PTO gear will be switched off.
- Pull the push-pull rod out.
The PTO speed will be 540 RPM at an engine speed
of 2200 RPM.
Bild_C992H_093
1
Bild_S 990_007
2
3