Holder C 9.92 H - Manual (Page 152)

C 9.92 Operating Instructions
150 153 146
Malfunctions, causes, remedy
Malfunction Cause Remedy
Joystick inoperative Joystick locked
Buttons defective
Release with Opus or PC software
Determine fault with Opus, submit the
joystick for repair, or replace it
Membrane keyboard inoperative Mechanically or electrically
defective Determine fault with Opus or PC
software, replace membrane keyboard
and/or related printed circuit board
Simultaneous failure of many joystick
and membrane keyboard functions Power supply interrupted
(3 separate positive cables, pin 05,
23, 34) Determine and eliminate the defect
(cable breakage, contact problems in
the plug) Attention: Although voltage is
applied in the quiescent state, power
failure can result during operation
Functions operate too slowly or too
fast Flow rate limiting out of adjustment
Current value for a certain channel
too low
Readjust with hash (#) key and joystick
or Opus or PC software
Adjust from 800 to 1900 mA in
"Channels" area with Opus or PC
software
4th control level on joystick
"malfunctioning" Special function activated with
asterisk (*) key Push the asterisk (*) key again
Joystick or membrane keyboard not
functioning Bus cable is defective (Opus does
not indicate a connection) Make a connection or replace the
cable