FUJITSU XG2600 - Manual (Page 22)

XG2600 Hardware Guide Chapter 1 Getting Started
Items in the Package, Descriptions and Functions 22
1.1.4 Switch Port Side
• PSU Slots for Rear-Access Installation
PSUs are plugged in the slots when the switch is used in Rear-Access configuration.
• Power Inlet Plug the attached Power Cable in the package.
• Power Supply Unit This switch is installed with two PSUs.
• SFP+ Slots Plug SFP+ modules for connecting Ethernet based networking equipment (10GBASE-
SR/10GBASE-LR).
Port number is assigned from the upper side of the leftmost port to the right. For
example, Port 1 is the upper side of the leftmost port, and Port 26 is the lower side of the
right most port.
• Reset Switch Press to reboot.
• USB Port Insert a USB memory device to load/save configuration files or update firmware.
• Serial Port (Console Connection)
The Serial Port is used to connect the switch with the console (PC) for setting and
command line interface via the attached console cable adapter (RJ45 to Serial Adapter)
and RS232C crossover cable (D-SUB9).
Caution
Serial Port is only used for connecting the switch with RS-232C interface of the console. Do not
connect other interfaces such as LAN/ISDN which cause an error.
• Management Port This is used to connect Ethernet based (10/100BASE-TX) networking equipment. Use
Category-5 LAN cables.
The Management Port is MDI fixed. If you connect the device that have MDI fixed port
to the Management Port, please use the Crossover Cable.
Reference User’s Guide "1.1.5 Console Port Specifications" (pg.29)
SFP+ Slots
Serial Port
PSU1
Power Supply Unit
Power Inlet
Management Port
USB Port
Reset Switch
PSU Slots for
Rear-Access Installation
PSU2
Power Supply Unit
Port1
Port2 Port26
Port25