FUJITSU XG2600 - Manual (Page 47)

XG2600 Hardware Guide Chapter 2 Installation
Connecting the Equipment 47
Connecting SFP+ Module
Firmly install SFP+ module to SFP+ slot and lock module to the switch.
Precautions
• Safely keep a guard cap of SFP+ module.
• Make sure to clean the end face of SFP+ module / optical cable before connecting optical connector because the
end face may possibly be contaminated.
• Do not directly touch the contact part of SFP+ module by hands. Use wristbands when touching SFP+ module.
• Connecting part to the optical cable of SFP+ module is the laser opening.
There are two types of SFP+ modules, veil latch type and standard latch type.
Below is how to connect.
• Veil Latch Type
Insert SFP+ module to the SFP+ slot with a lever locked, and lock the module and the switch.
Connect optical cable (connector shape: DLC) after inserting SFP+ module to the SFP+ slot.
When removing SFP+ module, unlock the lever, module and the switch, and remove the module after unplug the
optical fiber.
• Standard Latch Type
Insert SFP+ module to the SFP+ slot, and lock the module and the switch.
Connect optical cable (connector shape: DLC) after inserting SFP+ module to the SFP+ slot.
When removing SFP+ module, remove the module after pressing a tab to unlock the module and the switch.
SFP+ module
Lever
Tab