Remove rack mounting brackets, Change the direction of fans to adjust airflow – FUJITSU XG2600 User Manual
Page 38
XG2600 Hardware Guide
Chapter 2 Installation
Installation of the switch
38
2.2.3
Change Switch Access Configurations from Rear-Access
(Factory Default) to Front-Access and Install
This section describes how to change Rear-Access configuration (Factory Default) to Front-Access.
Remove rack mounting brackets
1.
Remove rack mounting brackets attached to the sides of the switch.
Change the direction of fans to adjust airflow
Change the direction of fans, depending on which switch access configuration to go with, Rear-Access or Front-Access.
Check the direction of fans before installing the switch in the rack.
Airflow is as shown below.
•
Rear-Access Configuration (Factory Default)
•
Front-Access Configuration
Note
For Front-Access configuration to Rear-Access, make the procedure reversed.
Rack Mounting Brackets
XG2600
Intake
Airflow Label
Exhaust
Exhaust
Airflow Label
Intake