FUJITSU XG2600 - Manual (Page 56)

XG2600 Hardware Guide Chapter 2 Installation
Set up IP address 56
2.6 Set up IP address
Please set the IP address at times when it is required.
Eg. When setting the switch through www browser or installing a firmware from the initial state of the purchase.
The following commands show how to set up the IP address (ex. 192.168.1.1)
z Command (When connecting through management port)
z Command (When connecting through10GBASE-R (SFP+) port)
Precautions
• The IP address is not set at the initial state of the purchase. Please set the IP address through console.
• When logging in by console, you will not be able to log in from the www browser. Please make sure to log off from
the console after setting up the IP address.
• Please set up different network address when setting “oob ip address” command and “lan ip” address command at
the same time.
XG2600# configure
XG2600(config)# oob ip address 192.168.1.1/24 3
XG2600(config)# commit
XG2600(config)# exit
XG2600#
XG2600# configure
XG2600(config)# lan 0 ip address 192.168.1.1/24 3
XG2600(config)# lan 0 vlan 1
XG2600(config)# commit
XG2600(config)# exit
XG2600#