Fujitsu Siemens Computers S60 - Manual (Page 72)

64 U41221-J-Z156-1-74
Mounting the Rack Model Installation
10.4.1 Preparing the Slide Rails
Before the slide rails can be screwed to the support uprights, a holding-down
clamp must be secured to each slide rail. Seen from the front of the rack, the
holding-down clamps are secured to the front area of the slide rails. They
prevent the storage subsystem from tilting down on removing it from the rack.
Figure 26: Securing the Support brackets to the Slide Rails
Ê Position the slide rails (1) on your work surface in the same way as they are
to be mounted in the rack, with the longer angular edge onto which the
storage subsystem will be placed at the bottom and on the inside.
Ê Position the holding-down clamps (2) on the slide rails from the outside so
that the drilled holes for your assembly match up on the slide rails and on
the holding-down clamps.
Ê For each holding-down clamp, insert two of the screws supplied (3) from the
inside through the drilled holes into the slide rails and into the holding-down
clamps and tighten the screws.
4
3
2
2
1
1