FireplaceXtrordinair 36 DV EFIII - Manual (Page 27)

Finalizing the Installation
2 7
Travis Industries 4040708 1 0 0 - 0 1 1 6 0
1 Remove the glass frame (and arch covers) following the directions below.
Warning: The appliance must be completely cool before removing the glass.
Note: If using an arch face, attach the arch covers after re-installing the glass.
Open the four latches holding the glass
frame in place (start with the bottom
two) - follow the directions shown to the
right.
a
The arch covers (included
in the owner's pack) block
light from exiting the scroll
work on arched faces.
The covers hang on the
glass frame.
Arch Faces:
Attach arch covers before
installing the face.
Rectangular Faces:
Discard the arch covers.
Arch Cover
Glass
Glass
Frame
Arch Covers (both sides)
Twist 1/4 turn.
The spring pin will
disengage from the
latch bracket,
opening the latch.
Latch Bracket
Insert the 1/4” key
into the spring
pin.
Glass
Top of
Firebox
Spring Pin
Glass Frame
Lift the glass frame up and
pull it forward to remove.
b
Re-Attaching the Glass Frame:
a) Hang the glass frame on the firebox.
b) While holding in place, attach the upper latches
(follow the instructions to the right in reverse).
c) Lift the glass frame slightly and attach the lower latches.
NOTE:
You may need to lift
the glass frame
while re-attaching.