Optional equipment, Power heat duct – FireplaceXtrordinair 36 DV EFIII User Manual
Page 46
4 6
Optional Equipment
(for qualified installers only)
Travis Industries
4040708
1 0 0 - 0 1 1 6 0
POWER HEAT DUCT
(part # 98500769)
The optional heat duct allows the fireplace to transfer heat to separate locations in the home.
One or
two ducts may be used
. Installation should take place prior installing drywall.
Warning: This kit must be installed as specified in these instructions. Do not modify any
component.
Warning: Use of any external blower other than the Travis Power Heat Duct Blower will void the
warranty and listing of this appliance and may create a fire hazard.
Note:
The power heat duct
must be installed by a qualified service technician.
Note:
Some building codes
may require the use of
firestop spacers
whenever the duct
passes from room to
room.
Note:
When routing ducts
through a cold area
(e.g. crawl space) we
recommend insulating
the duct with fiberglass
insulation. If paper-
backed insulation is
used, the paper can not
contact the duct.
Electrical
Source
Starter Ring
Use 10” x 3-1/4”
wall stack (duct)
when passing
through tight
areas.
6" Duct
Duct Adapter
(6” Round to 10” x 3-1/4”)
Floor
Boot
Grill
Rheostat
(with cover plate)
Junction Box
Wall Adapter
(for use on
2 x 4 walls)
Heat Duct
Electrical
Wiring
Blower
Box
Maximum Duct
Length = 20'
•
Determine the route for the heat duct using the illustration below as a guide.
Use 10” x 3-1/4” wall stack
(duct) when passing
through tight areas.
20’ Maximum
Length
Duct Adapter
(6” Round to 10” x 3-1/4” -
included with the power heat
vent kit)
Blower Box
0” Clearance to
Combustibles
Co-Axial Vent
(for intake air
and exhaust)
NOTE:
Air flow through the duct is affected by
length and number of bends. Keep the
length and number of bends to the minimum
to maximize performance.
When the duct penetrates the
fireplace enclosure vertically and the
top of the enclosure is within 36” of
the top of the fireplace, a firestop
spacer that maintains a 1/2”
clearance between all sides of the
duct and any combustible material
must be used.
1/2”