FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 422)

24-8 SPARC Enterprise M8000/M9000 Servers Service Manual • August 2009
FIGURE 24-5 Mounting the Connector Unit (Rear of M8000)
o. Mount the two brackets (with two screws each) for securing the ACS on the
side panel at the rear of the equipment rack of the M8000. For their
mounting locations, use the second and third holes from the bottom, and
secure them.
p. From the rear of the server, mount the ACS mounting frame, and secure it at
the rear of the server (with three screws each on both sides). Secure the two
brackets for securing the ACS (one screw each) and the dual power feed unit
at the rear of the server (with three screws on each side).
q. Secure the ACS mounting frame and the two brackets mounted in Step o
with screws (one screw each).