FUJITSU SPARC ENTERPRISE M8000 - Manual (Page 499)

Appendix D UPS Controller D-5
D.5 UPS Cable
The UPS cable specifications are as follows:
■ Connector shape
D-SUB9 pin male (receptacle side: female)
DEU-9PF-F0
■ Terminal array
FIGURE D-2 shows the pin signals of the UPC port and UPS cable.
Do not use any pin that is not defined (Pin 2, 3, 4, and 8 in FIGURE D-2 ). The pins
on the cable side are as follows:
FIGURE D-2 Correspondence between the UPC Ports and the UPS Cable Pins
Remarks: If a UPS cable is required, it must be prepared separately. For details,
contact your sales representative.
Note: Do not connect to the ER signal pin.
(Note)
*BTL
*BPS/*UALM
*ACOFF
SG
ER
UPC port side UPS cable side
*BTL
*BPS/*UALM
*ACOFF
SG
1
2
3
4
5
6
7
8
9
Pin
number
Signal name
---
---
---
---