FANUC Robotics America V7865* - Manual (Page 36)

36
1
V7865 Product Manual
Front Panel
Connectors
The V7865 provides front-panel access to the PMC expansion site, the VGA connector,
the two GbE connectors, the manual reset switch, COM1 port, two USB ports, the
Mouse/Keyboard, and the status LEDs. A drawing of the V7865 front panel is shown
in Figure 1-5 on page 37. The front panel connectors and indicators are labeled as
follows:
• LAN1 GbE connector
• LAN2 GbE connector
• VGA VGA video connector
• RST Manual reset switch
• COM1 COM port
• M/K Combination mouse/keyboard connector
• USB USB connectors
• BPHT Status LEDs
The V7865 provides rear I/O support for VME with 2eSST 320MB/s, the optional
PMC I/O (Vita 35), DVI-D, two USB 2.0 ports, COM2 (RS232/RS422), and two SATA
drives. These signals are accessed by the use of a rear transition module (RTM) such
as the ACC-0602RC or the ACC-0603RC, which terminate the signals into industry
standard connectors. The front panel connectors, including connector pinouts and
orientation, for the V7865 are defined in Appendix A "Connector Pinouts".
NOTE: RTMs may not support all available V7865 rear I/O mentioned above. RTM
connections are defined in the appropiate RTM Installation Guide. See the V7865
product specification for compatible RTMs offered by GE Fanuc Embedded Systems.
LEDs
See Figure 1-5 on page 37 for a diagram of the Rugged Front Panel option. Beside the
diagram are the definitions of the various LEDs on the front panel. The connections
and the LEDs are the same for the Standard Front Panel option, which is shown in
Figure 1-6 on page 39.