FANUC Robotics America V7865* - Manual (Page 75)

75
VME Connector Pinout (P1 and P2)
A
VME Connector Pinout (P1 and P2)
Figure A-2 and Table A-1 show the pin assignments for the VME connectors. Note
that only Row B of connector P2 is used; all other pins on P2 are reserved and should
not be connected.
Figure A-2 VME Connector Diagram (P1/P2)
WARNING : The V7865 board should not be used with IDE rear cabling that is
compatible with any VME-74xx boards, except for the VME-7469, which supports
SATA.
Table A-1 VME Connector Pinout (P1/P2)
Pin#
P1 Row A
Signal
P1 Row B
Signal
P1 Row C
Signal
P2 Row Z
Signal
P2 Row A
Signal
P2 Row B
Signal
P2 Row C
Signal
P2 Row D
Signal
1 D00 BBSY# D08 CONN [2] GND VCC_5.0 SP1_TX CONN [1]
2 D01 BCLR# D09 GND USB_P5N GND SP1_RTS# CONN [3]
3 D02 ACFAIL D10 CONN [5] USB_P5P RETRY# SP1_DTR# CONN [4]
4 D03 BG0IN# D11 GND USB_OC5# A24 SP1_RX CONN [6]
5 D04 BG0OUT# D12 CONN [8] GND A25 SP1_DCD# CONN [7]
6 D05 BG1IN# D13 GND USB_P4N A26 SP1_CTS# CONN [9]
7 D06 BG1OUT# D14 CONN [11] USB_P4P A27 SP1_DSR# CONN [10]
8 D07 BG2IN# D15 GND USB_OC4# A28 SP1_RI# CONN [12]
9 GND BG2OUT# GND CONN [14] GND A29 RTM_
SCONF_GP CONN [13]
10 SYSCLK BG3IN# SYSFAIL# GND USB_P3P A30 VCC_5.0 CONN [15]
11 GND BG3OUT# BERR# CONN [17] USB_P3N# A31 VCC_-12 V CONN [16]
12 DS1# BR0# SYSRST# GND USB_OC3# GND GND CONN [18]
13 DS0# BR1# LWORD# CONN [20] GND VCC_5.0 SATA1_RXN CONN [19]
14 WRITE# BR2# AM5 GND USB_P2N D16 SATA1_RXP CONN [21]
32 1 32 1 P2 P1
Row
D
C
B
A
Z