FANUC Robotics America V7865* - Manual (Page 95)

95
Security Setup
B
Security Setup
The ezPORT setup provides both a Supervisor and a User password. If you use both
passwords, the Supervisor password must be set first.
The system can be configured so that all users must enter a password every time the
system boots or when ezPORT setup is executed, using either the Supervisor
password or the User password.
v02.59 (C) Copyright 1985-2005, American Megatrends, Inc .
NOTE: Options shown may not be available on your system.
To reset the security in the case of a forgotten password you must drain the NVRAM
and reconfigure.
To clear the CMOS password:
• Turn off power to the unit.
• Momentarily short pins of E11 for approximately five seconds.
• Power up the unit.
When power is reapplied to the unit, the CMOS password will be cleared.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Security Settings Install or Change the
password.
←→ Select Screen
↑↓ Select Item
Enter Change
F1
General Help
F10 Save and Exit
ESC Exit
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
Clear User Password
Boot Sector Virus Protection [Disabled]
Hard Disk Security