FUJITSU M3000 - Manual (Page 121)

9-1
C H A P T E R
9
Replacement and Installation of a
Hard Disk Drive (HDD)
This chapter explains how to replace and install a hard disk drive.
■ Section 9.1, “Accessing a Hard Disk Drive” on page 9-3
■ Section 9.2, “Removing a Hard Disk Drive” on page 9-4
■ Section 9.3, “Installing a Hard Disk Drive” on page 9-6
■ Section 9.4, “Reassembling the Server” on page 9-6
Hard disk drives are active/hot/cold replacement components.
Note – The hard disk drive will have a redundant configuration by setting the
mirroring.
Note – ■ If a hard disk drive is a nonmirrored boot device, it must be replaced
according to the cold replacement procedure.
■ If a hard disk drive is in a mirrored configuration, active replacement can be
performed on the failed drive because the mirrored hard disk drive continues to be
online and functioning. The hard disk replacement procedure varies by the
mirroring configuration method. When it is configured with hardware RAID, see the
SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers Administration Guide.
When it is configured with software RAID, see the manuals for the software in use.
The same methods as those for replacement are used for installation of a hard disk
drive.