FUJITSU M3000 - Manual (Page 134)

10-6 SPARC Enterprise M3000 Server Service Manual • February 2011
4. Mount the hard disk drives.
For details, see Section 9.3, “Installing a Hard Disk Drive” on page 9-6 .
5. Mount the CD-RW/DVD-RW drive unit.
For details, see Section 11.4, “Mounting the CD-RW/DVD-RW Drive Unit” on
page 11-6 .
10.4 Reassembling the Server
1. Attach the air duct.
For details, see Section 5.3.2, “Attaching the Air Duct” on page 5-6 .
2. Attach the top cover.
For details, see Section 5.2.2, “Attaching the Top Cover” on page 5-4 .
3. If the equipment rack is supplied with a Quake-Resistant Options Kit or
stabilizer, return to its original position.
For details, see Section 5.1.2, “Sliding the Server into the Equipment Rack” on
page 5-3 .
4. Power on the server.
This procedure includes the steps of reconnecting the power cord, checking the
LED status, and turning the mode switch on the operator panel to the Locked
position. For details, see
Section 4.5.3.1, “Power-on by Using the XSCF
Command” on page 4-13 .
Note – If automatic startup of the Oracle Solaris OS is specified, use the sendbreak
-d domain_id command of the XSCF Shell to display the ok prompt after the
display console banner is displayed but before the system starts booting the Oracle
Solaris OS.
5. Check the hardware.
This procedure includes the steps of running a program to verify that all the
components have been remounted and to start the Oracle Solaris OS.
For details, see Section 4.5.4, “Verifying the Hardware Operation” on page 4-15 .