FUJITSU M3000 - Manual (Page 53)

Chapter 3 Troubleshooting 3-15
3.5.3 Using the showstatus Command
The showstatus command displays information about faulty or degraded units
that are among the FRUs composing the server and information on the units on the
layers immediately above the layers of the faulty or degraded units. For each of the
displayed units, an asterisk (*) indicating that the unit is faulty is displayed with any
of the following status indicators, which is displayed after "Status:".
■ Normal: Normal state
■ Faulted: The unit is faulty and is not operating.
■ Degraded: The unit is operating. The unit is partly faulty or degraded and some
error has been detected. Although a faulty state is displayed for the unit, it is
operating normally.
■ Deconfigured: There is no problem with the unit itself, but it is degraded due to a
configuration problem, environmental problem, or the degradation of another
unit.
■ Maintenance: Maintenance is being performed. replacefru(8) or addfru(8) is
being executed.
XSCF> showstatus
FANBP_B Status:Normal;
* FAN_A#0 Status:Faulted;
XSCF>